Short answer: electric gate troubleshooting starts with matching the symptom to the likely cause. Gates that won’t close usually have a photo-eye problem. Gates that won’t respond usually have a power or remote problem. Gates that grind or stall usually have a mechanical problem. You can safely clean, clear and reset. Repairs to the motor, board, wiring or force settings belong to a trained technician.
Below is the electric gate troubleshooting chart our techs use in Portland and Seattle, written for homeowners. It tells you what you can try and when to stop.
Electric gate troubleshooting by symptom
The gate won’t close, or it reverses
Likely cause: photo eyes are blocked, dirty, wet or out of line. Sometimes the force setting has drifted or the gate is dragging.
You can try: wipe both lenses, line them up, and clear the path.
Call a tech if: it still reverses with clean, lined-up eyes.
Nothing happens at all
Likely cause: a tripped breaker or GFCI, a blown fuse, a dead backup battery, or a failed control board.
You can try: check the breaker and outlet, then turn the power off for a minute and back on.
Call a tech if: there’s still no power light, or you see burn marks.
The motor hums but the gate doesn’t move
Likely cause: the gate is in manual release, a gear is stripped, the capacitor has failed, or the gate is jammed.
You can try: check that manual release is engaged and nothing blocks the gate.
Call a tech if: it still hums. Running it like this can burn out the motor.
The remote doesn’t work but the keypad does
Likely cause: a dead remote battery, a lost code, or receiver interference.
You can try: a new battery, and standing closer.
Call a tech if: several remotes fail. The receiver or antenna may need replacing.

The keypad or intercom is dead
Likely cause: water in the keypad, damaged low-voltage wiring, or lost programming after a surge.
Call a tech: keypads and intercoms usually need a technician. See our keypad and intercom service.
The gate grinds, jerks or stops partway
Likely cause: worn rollers or hinges, a dry chain, limits out of adjustment, or a weak battery.
You can try: clean the track and lubricate the exposed hinges.
Call a tech if: the noise continues or the gate sags.
The gate was hit by a car
Disconnect power and keep people clear. A bent gate or arm can put huge strain on the operator and fail in an unpredictable way. This is a technician job, and often an emergency one.
Why most electric gate repairs aren’t DIY
Gate operators push hundreds of pounds and run on line voltage. Their safety features, like photo eyes, reverse sensing and force limits, are what keep people and cars from getting hurt, and operators are built to standards such as UL 325. Changing those settings without the right tools can disable the safety features. In Oregon, hire a licensed contractor; you can check a license with the Oregon CCB. Ours is CCB #259574.
How Safe Haven Gates fixes it
We repair every major brand, including LiftMaster, DoorKing, Apollo and Viking. Our trucks carry the common parts, so most repairs are done the same day. We find the cause, tell you the price, then fix it. Portland-area customers call (503) 455-7393. Seattle, Bellevue, Tacoma and Everett customers call (425) 470-4166.
Frequently asked questions
What is the most common electric gate problem?
Photo-eye problems: dirty, wet or misaligned sensors that stop the gate from closing.
How much does electric gate repair cost?
It depends on the part and the operator. A sensor alignment costs far less than a new circuit board. We quote before we start. See electric gate repair.
Can you fix my brand of gate opener?
Very likely. See the brands we repair.
Book a repair: Portland (503) 455-7393, Seattle (425) 470-4166.


